perfect for bathrooms; it can also be used in kitchens, hallways and back rooms. Although the floor

perfect for bathrooms; it can also be used in kitchens, hallways and back rooms. Although the floor covered with ceramic tiles, cool and loud, just wash it and it is durable. Methods floor facing similar techniques ewbank facing walls, the difference is that the floor tiles are thicker and harder to cut and work starts from the middle of revetted areas rather than in one corner. Again, again, reason Tile (floor covering or dark) should be properly prepared, in other words, be strong and rovnenko. ewbank If nastelyatymetsya flooring in the bathrooms, the design of the base should be laid waterproofing.
Finding center of the room (along ewbank the lines of markup), choose one of the options for the center point, one tile is exactly in the center, two tiles are joined in the center, or four tiles are joined to the central point. The center point can move based on your room (such as a fire) or for laying tiles diagonally. Starting from the center, put dry test row of tiles (leaving gaps on joints) along and across the room. Maybe the center point will move to the last tile had similar width (not less than half the width of the tile). Divide the room in half and prybyyte along this strip rail (or swipe the latest line marking).
Because rail later you have to shoot, Ram nails shallow. Cement screed using thick nails. In the far door half the room put on plot length of 1 m and a width slightly greater than the width of tile. Starting from the center, lay the tiles close to the rail using the console to create a seam gaps between tiles. Some manufacturers are advised to apply glue and very tile and the floor (see annotation manufacturers of adhesive and tiles).
Glue is applied to a notched trowel. By installing the first tile, then remove it and flip. See which occupies an area of adhesive on the tile. If the glue covers the entire tile, trowel teeth mean height chosen correctly. If the tile is not the place covered with glue, it is necessary to change the spatula on the other, with higher teeth. Glue can be applied on the basis of any equipment: spatula, trowel or Iron. And flatten it must only notched trowel. ewbank
Spatula is placed at right angles to the base and extends. For all this his teeth should prodyraty glue ground to pass a spatula after him rovnenko were similar in height strip adhesive. This is to ensure that the adhesive under the tiles was necessary height. When you push the floor tiles, adhesive strips crush and occupy the entire area of the tile. This is a fundamental point in prykleytsi tiles to the base. Pay close attention to it and select the spatula with the height of the teeth to glue fully occupied the entire area of the tile and not vydavlivalsya the surface.
Wet or not wet glaze tile? Read abstract manufacturer of glue, in most cases wet tiles do not. When working with glue or leave it on the basis of neulozhennye him tile more than 15 minutes. After graduating still appears on glue plastic film that prevents setting adhesive and tile adhesive should then jump inside the tile, not outside. So spread this amount of glue as you can conclude tiles for 10 15 minutes. Having laid the first tile glue, check the small horizontal level: along, across and diagonally.
The following tiles stacked next to the first and further inspect ewbank long levels set one end on the first tile on the other concluded. With this technology, when installed lighthouse wood rails, and any enclosed tile tested long level pull cords guides ewbank and teaching of reference tiles do not. Laying the floor covering shall promptly and without much straining.
When laying tile adhesive with mizhplytkovyh pick out gaps (only with gaps, not to the base), here we are then, and often rub the cloth laid tile. For check equality styling. If necessary, sediment tiles, tapping with a hammer on a flat wooden rail. Put half tiled room. When the glue take hold, carefully remove the rod and put the other half tiled rooms, graduating at the door. End (Frieze) tiles are placed in the least, when the adhesive under the tiles and background to take hold of flooring can go.
Do not place the tiles in the final thrust ewbank to the wall, finish laying tile seam. Mark the end tiles, using the method of three tiles: ewbank put a tile at last concluded a tile, floor tile her third place (near a wall, place the prefix); then on average tile draw a line using the top tile as a guide. The best tool for trimming tiles. ewbank
Make a notch on the tile, then pressing the hand of the end tiles oblamayte her nasichtsi. Before laying the final tile